Carrier Transicold Vector - Setting and Viewing Unit Data; Temperature Setpoint Adjustment; Accessing Unit Data

EASY TO
SET
Temperature Setpoint
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
With the message center at the
default display press the UP
ARROW or DOWN ARROW key to
change setpoint to the desired
value.The display will flash to indi-
cate that the setpoint reading
being displayed is a non-entered
value. The message center will
show “ TO SCROLL, THEN = TO
SAVE”.The setpoint display will
flash for 5 seconds if = has not
been pressed.
Verify that the message “SETPOINT CHANGED” is
displayed on the message center.
Press the = (ENTER) key to save the new
setpoint.
EASY TO
READ
Unit Data
SETPOINT
BOX TEMPERATURE
START/RUN
STOP
1
0
STANDBY
ENGINE
LANGUAGE
CONTINUOUS
RUN
START-STOPALARMDEFROSTCOOLHEAT
MANUAL
DEFROST
ALARM LIST
START-STOP
CONTINUOUS
SELECT
=
!
DATA
Press the SELECT key until DATA is
illuminated.
Press the = key.
Press the UP or DOWN ARROW key to display the
next or previous unit data value.
1
1
2
2
3
3
SUCTION PRESSURE:
1
1
2
2
3
3
SETPOINT CHANGED