Setting up the TruVu™ ET display
TruVu™ ET Display (part# EQT3) ©2022 Carrier.
Installation and Start-up Guide All rights reserved.
10
After successfully connecting the power and communication wiring, one of the following appears:
○ If you do not have custom screens, the System screen appears. See TruVu™ ET display screens (page
16).
○ If you have custom screens for the TruVu™ ET display, the following screen appears while the files load.
Then the Home screen appears.
Touch
to access the Application Settings without connecting to the controller. See TruVu™ ET display
screens (page 16) for information on the Application Settings screen.
NOTE The TruVu™ ET display can take up to 20 seconds to start updating after communication is established,
and up to 20 seconds to indicate a loss of communication.
To edit the touchscreen settings
Changes to the display are made on the Quick Settings pane. To display the pane, swipe down from the top of the
touchscreen.
Setting up the TruVu™ ET display
To Next Page
Loading...