Carrier TruVu ET Display7 - Wiring the Truvu ET Display; Wiring for Power

Wiring the TruVu™ ET display
TruVu™ ET Display (part# EQT3) ©2022 Carrier.
Installation and Start-up Guide All rights reserved.
6
Wiring for power
Connect the TruVu™ ET display to either a:
• 24 VDC power supply using 2-conductor wire 18 AWG.
• 24 VAC power supply using a NSA-A/PS24-24V-S low voltage power supply
NOTE Must be within 100 feet (30 meters).
WARNING Do not apply line voltage (main).
CAUTION The TruVu™ ET display can share a power supply with the Carrier controller as long as:
• The power supply is DC power.
• You maintain the same polarity.
• You use the power source only for Carrier controllers.
NOTE Purchase a power supply from a third-party manufacturer.
Wiring the TruVu™ ET display