Mounting the TruVu™ ET display
TruVu™ ET Display (part# EQT3) ©2022 Carrier.
Installation and Start-up Guide All rights reserved.
4
The TruVu™ ET display must be mounted within the building interior. You can mount the TruVu™ ET display:
• In a panel with the controller or on the panel door
• On a wall within 500 feet (152 meters) from the controller
• Within 100 feet (30 meters) of its power supply
• With a wall mounting kit (7” and 10” only)
You can mount the panel using either of the two options below.
Option 1 - Panel mounting
1 Cut opening in the panel door to size specified in punchout table below.
Punchout Size, Width x Height
TruVu™ ET display-7 6.9 x 4.646 in. (17.5 x 11.8 cm)
TruVu™ ET display-10 9.607 x 6.26 in. (24.4 x 15.9 cm)
Mounting the TruVu™ ET display
To Next Page
Loading...