Document revision history
UPC Open Carrier Proprietary and Confidential CARRIER CORPORATION ©2017
Installation and Integration Guide All rights reserved
24
Important changes to this document are listed below. Minor changes such as typographical or formatting errors are not
listed.
ZS Sensor overview
Wireless sensor overview
Changed driver to 6.04-xxx
Select or create a custom control
program and graphic for the UPC Open
Custom control programs and graphics for ZS sensors, wireless
sensors, or touchscreen, require the February 2017 or later
cumulative update.
Specifications
Wiring devices to the UPC Open's Rnet
port
The following note added:
The UPC Open only supports ZS sensors, Equipment Touch, and
wireless sensors using the 6.04.xxx or later driver.
Wireless sensor overview
To install the Wireless Adapter for
Wireless sensors
To wire an Equipment Touch to the UPC
Open
Wiring devices to the UPC Open's Rnet
port
Added Wireless Adapter for wireless sensors and Equipment
Touch
To wire the controller to the BACnet
network
Added BACnet ARC156 connection information
Wiring for communications
Changed from Wiring the UPC Open to the MS/TP network
Warning added to disconnect controller before wiring.
Added ARC156, Equipment Touch, ZS, and Wireless Adapter for
Wireless sensor capability.
Cover
What is the UPC Open?
Changed to latest controller image.
All references to BACview removed
Local access to the UPC Open
Added USB Link wiring caution.
Corrected Universal Protocol Card to Unitary Protocol Converter
Changed Maximum number of BACnet objects to Unlimited from
1050
Added information on using the Factory Defaults jumper
Document revision history