62-11637 3–12
1. With the system powered up (START/RUN-OFF switch in the START/RUN position) or in PC Mode press
the MENU key until DATA RECORDER is displayed.
2. Press the DATA RECORDER soft key to display the sub menus.
3. The Data Recorder screen will display with a 15 second timeout. Press the ▲ or ▼ key to scroll through the
available sub menus. With the desired sub-menu highlighted, press the “=” Key to enter the menu.
MARK TRIP START
Trip Start places the present time and date as a stamp in the data recorder memory to allow easy
review of the data from the last trip, and to allow downloading data from a specific trip. A trip begins at a
Trip Start and ends at the next Trip Start. To enter a Trip Start: with MARK TRIP START highlighted,
press the “=” Key. If trip start is acknowledged by the data recorder, “TRIP START ENTERED“ will be
displayed for 5 seconds and then the display will revert back to the normal display. In the unlikely situa-
tion that the data recorder is not functioning properly “CANNOT ENTER TRIP START” will flash and
then the display will revert back to the Data Recorder menu.
PRINT TO SCREEN
PRINT TO SCREEN displays a graphical representation of the recorded data. To display the data: with PRINT TO
SCREEN highlighted, press the “=” Key. NOTE: If configured to do so, the system will prompt for entry of the data
protect PIN code (refer to “PROTECT DATA WITH PIN”, Table 5–1)
Once the graphical display is presented, press the ▲ or ▼ keys to move through the recorded data, day by day.
The data is presented with the left horizontal axis as 00:00 (midnight) with 24 dividing lines representing the hours
of the day. Press the “=” key to toggle the event codes on or off. When viewing events with the event codes ON, the
following acronyms will be displayed:
c = Door Close o = Door Open
d = Defrost start p = Power up
e = Defrost end r = Real time clock change
f = Power down t = Trip Start
CONTINUOUS
START/STOP
MENU
ALARM
COOLDIESELSTART/STOP
INTELLISET
Viewing Menu Soft Key
Selections
Press Menu Key to Scroll
PRETRIP HOUR
METERS
UNIT
DATA
DEFROST
COOLDIESELSTART/STOP
LANGUAGE
Viewing Menu Soft Key
Selections
Press Menu Key to Scroll
DATA
RECORDER
EXIT
1
2
BACK EXIT
MARK TRIP START
PRINT TO SCREEN
PRINT TO PRINTER
SCREEN SETUP
PRINTER SETUP
DATA RECORDER
NOTE: Choices vary based on
software revision and model
type.
EXIT
Collecting Data, Please Wait
Up Key = Next Day
Down Key = Previous Day
Equal Key = Event Toggle
EXIT
75
60
45
30
15
RAT
SAT
SETPOINT
Time & Date
SP
To Next Page
Loading...
