62-11637 5–8
5.3 USB MEMORY DEVICES
Instructions for using USB memory devices with the APX control system are provided in the following sub-para-
graphs.
5.3.1 Data Transfer USB Memory Device
A Data Transfer USB memory device may be created for use with the APX control system using a standard USB
device of 1 gigabyte capacity or greater.Instructions for creating a Data Transfer device are provided in Figure 5.6.
Once the Data Transfer USB memory device is created:
• The device may be used to enter PC Mode.
• Data files from the DataLink data recorder may be transferred from the control system to the “DATAEXT’
folder.
• Software files may be transferred to the “PROGRAM” folder and then transferred to the control system.
• IntelliSet/Configuration files may be transferred to the “CONFIG” folder and then transferred to the control
system.
Figure 5.6 Creating a Data Transfer USB Memory Device
1. Using a standard computer file creation program, create a folder on the device labeled CARRIER. The file
name must be in all uppercase letters.
2. Open the CARRIER folder and create three sub-folders labeled DATAEXT, CONFIG and PROGRAM. The
file names must be in uppercase letters.
3. The device is now ready to be used as a Data Transfer USB Memory Device.
To Next Page
Loading...
