62-11637 5–2
3. Press the ▲ or ▼ key to scroll through the list of menu items. Press the “=” key to enter the settings or test
modes.
NOTICE
Technician Mode should be canceled when work is complete. If Technician Mode is not can-
celed, Technician Mode will be available for 60 minutes after the last key press without requir-
ing a code, even after placing the SROS in the OFF and then back in the RUN/STOP position.
4. Once activity requiring use of Technician Mode is complete, Technician Mode should be manually canceled.
• To cancel from the TECHNICIANS MENU screen, highlight CANCEL TECHNICIAN MODE/PIN
ACCESS and then press the “=” key. This will return he system to the Advance User Mode.
• To cancel from any screen, press and then release the two outside soft keys simultaneously (note: the
system will not respond) and then press the “=” key. The system will return to Driver Mode.
5.2.1 Technician Hour Meters
Hour meters, other than the standard hour meters, are available for viewing when the control system is in the Tech-
nician Mode. Instructions for viewing these hour meters are provided in Figure 5.2.
Figure 5.2 Technician Hour Meters
1. Enter the Technician Mode, as described in Figure 5.1. While in the TECHNICIANS MENU screen, press
the BACK or EXIT key and then press the MENU key until HOUR METERS is displayed.
2. Press the HOUR METER soft key to display the hour meter screen.
CONTINUOUS
START/STOP
MENU
ALARM
COOLDIESELSTART/STOP
INTELLISET
Viewing Menu Soft Key
Selections
Press Menu Key to Scroll
PRETRIP HOUR
METERS
UNIT
DATA
DEFROST
1
2
BACK EXIT
Standard Hour Meters
Other Meters & Counters
Maintenance Hour Meters
Reset PM Hour Meters
HOUR METERS
END OF LIST
(1 OF 4)
Note: This line will only display if
one or more meters has timed
out and is ready to be reset.
To Next Page
Loading...
