23
3.2.3 Equipment monitoring - floor navigation mode
Use of floor navigation system, Easy to quickly find an indoor units .The control interface is shown in the
picture below
Floor navigation map
① Status display. The interface can display the four basic states of "power on/power off/failure/offline". The
current wind speed and temperature mode of the IDU cannot be displayed
② "Full on/full off" button, click full on to open all devices in the current partition, click Full off to close all
devices in the current partition
③ Navigation map, can import floor map, Does not support in the "building"/" partition "import map, map
format support PNG, JPEG and other common picture format, maximum support 1440*900
Note: Click the device in the floor navigation interface to enter the control interface, but multi - system
control is not supported
①
②
③
To Next Page
Loading...
