29
3.3.2 HRV control
HRV control interface, as shown in the figure below
① Mode and air quality parameters display, showing the current operating mode, the mode is divided into
"automatic/full heat/bypass/fresh air/exhaust air/internal circulation", when installing optional air quality
sensing equipment, this point is the air quality parameter.
② ON/OFF button .to switch ON and OFF the controller.
③ Mode settingbutton, click to select the HRV control mode
④ Fan speed control button, click to select HRV fan speed
⑤ Order sending button. click the button to send the current control orders to all the selected HRV
units .Click once to send the command and exit the current control interface.
⑥ Selection button. you can select the HRV which you want to control.
①
③
④
⑤
②
⑥
To Next Page
Loading...
