1
INTRODUCTION------------------------------------------------1
1. INSTALLATION---------------------------------------------------2
Unpacking---------------------------------------------------------------2
Illustration of the installation for plastic shield-------------------2
Selecting the Location-----------------------------------------------3
Leveling the scale-----------------------------------------------------3
Connecting Power-----------------------------------------------------3
AC power------------------------------------------------------3
Battery power-------------------------------------------------4
2.6 Initial Calibration------------------------------------------------------4
2. OVERVIEW OF DISPLAY INDICATORS AND KEYBOARD
FUNCTIONS-------------------------------------5
Display Symbols-------------------------------------------------------5
Keyboard Functions---------------------------------------------------6
3. OPERATIONS-----------------------------------------------------7
Weighing mode---------------------------------------------------------7
4.1.1 Units Selection--------------------------------------------------7
4.1.2 Zero Function---------------------------------------------------7
4.1.3 Tare Function---------------------------------------------------7
4.1.4 Over load alarm------------------------------------------------8
4.2 Counting mode--------------------------------------------------------8
4.3 Percentage (%) mode------------------------------------------------9
4. PARAMETER SET-UP------------------------------------------10
Calibration---------------------------------------------------------------11
To choose the initial unit while turning on------------------------12
To choose the “UNIT” you need------------------------------------13
To choose the time of AUTO OFF----------------------------------14
To choose output transmission method---------------------------15
Baud rate setting for RS232 interface-----------------------------16
To choose the range of stability-------------------------------------17
To choose the Zero display range----------------------------------18
To choose the Zero Recovery display range -------------------19
To choose the auto-average in sampling on counting mode-20
To choose Backlight mode-----------------------------------------21
5. AUTO CALIBERATION-----------------------------------------22
6. RECOVERY OF THE DEFAULT VALUES FROM MEMORY----22
7. ERROR MESSAGES-------------------------------------------22
8. SPECIFICATION OF RS-232 INTERFACE--------------23
9. CONVERSION UNITS TABLE FOR WEIGHTS---------25
10. TABLE LIST FOR FULL CAPACITY------------------------25
12.TECHNICAL DATA------------------------------------------26
To Next Page
Loading...
Need help?
General
