23
6. AUTO CALIBRATION
Press the key for about 3 seconds. The display will show the
“Calibration weight value.” Put the same weight on the pan. When the
“CAL” symbol disappears, the calibration procedure is finished.
7. RECOVERY OF THE DEFAULT VALUES FROM
MEMORY
During in weighing mode, hold down the key for 3 seconds. The
scale will come back with a default calibration values.
8. ERROR MESSAGES
During self test the scale verifies operation and the load cell.
Error messages are: “
” messages.
These messages may also be shown if the pan is not installed correctly or
the environment is not suitable.
Contact your dealer for assistance.
To Next Page
Loading...
