Cascade F Series - Sideshift Cylinder; Cylinder Speed Adjustment; Cylinder Removal

ERVICE
S
22
208743 Rev. 1
FP0042.eps
FP0274.eps
FP0080.eps
5.4 Sideshift Cylinder
5.4-1 Cylinder Speed
Adjustment
The sideshifting speed can be adjusted by modifying the
restrictor washer in the cylinder base end port.
5.4-2 Cylinder Removal
2
WARNING: Before removing any hoses,
relieve pressure in the hydraulic system.
Turn the truck off, then actuate the truck
control valve several times in both directions.
WARNING: Before removing any hoses,
relieve pressure in the hydraulic system.
Turn the truck off, then actuate the truck
control valve several times in both directions.
1 Disconnect the hose or tube, fitting and restrictor from
the cylinder base end port.
2 Increase Speed – Enlarge the restrictor washer orifice
to no greater than .100 in. (2.5 mm) dia.
NOTE: Completely removing the washer may result in
excessive sideshift speed.
Decrease Speed – Braze the restrictor washer orifice
closed, then drill the orifice less than .080 in. (2 mm)
diameter.
1 Disconnect the hoses or tubes from the cylinder ports.
Tag the hoses for reassembly.
2 Remove the clevis pins from the cylinder ends.
3 For reassembly, reverse the above procedures except
for the following special instructions:
• Operate the sideshifter through several full cycles
to force air in the system to the truck hydraulic tank.
Check for leaks at all fittings.
2
1