Cascade F Series - Fork Position Cylinder; Cylinder Removal

ERVICE
S
25
208743 Rev. 1
FP0070.eps
5.5 Fork Position Cylinders
5.5-1 Cylinder Removal
WARNING: Before removing any hoses,
relieve pressure in the hydraulic system.
Turn the truck off, then actuate the truck
control valve several times in both directions.
1 Disconnect the hoses from the cylinder ports. Tag the
hoses for reassembly.
2 Remove the clevis pins from the cylinder base end.
3 Remove the cylinder anchor pins from the carrier lug.
For reassembly, tighten the capscrew to a torque of
16-18 ft.-lbs. (22-25 Nm).
4 For reassembly, reverse the above procedures except
for the following special instructions:
• Operate the fork position function through several full
cycles to force air in the system to the truck hydraulic
tank. Check for leaks at all fittings.
2
3
1