Case IH 91 Series - Install the Pressure Hose; Install the Tank Hose

Manual No. 016-5032-006 13
Hydraulic System Installation
Install the Pressure Hose
FIGURE 6. Pressure Hose Installed
1. Disconnect the machine’s pressure hose from the steering orbital.
2. Install a -12 M/M/F swivel run tee adapter fitting (P/N 333-0012-109) in the open port of the steering orbital.
3. Connect the machine’s pressure hose to the straight end of the installed tee fitting.
4. Install -12 JIC female to -10 JIC male reducer (P/N 333-0012-371) to 90 degree port on installed tee fitting.
5. Install the 90° end of the supplied hydraulic hose (P/N 214-1000-900) on installed reducer fitting.
6. Connect the straight end of the installed hydraulic hose to the fitting installed in Port P of the SmarTrax
valve.
Install the Tank Hose
FIGURE 7. Tank Hose Installed
1. Disconnect the machine’s tank hose from the steering orbital.
2. Install a -12 JIC M/M/F swivel run tee adapter fitting (P/N 333-0012-109) in the open port of the steering
orbital.
3. Connect the machine’s tank hose to the straight end of the installed tee fitting.
Machine’s
Pressure Hose
Supplied Hose
(P/N 214-1000-900)
Supplied Male Reducer
(P/N 333-0012-371)
Supplied Tee Adapter
(P/N 333-0012-109)
Machine’s Tank Hose
Supplied Hose
(P/N 214-1000-900)
(Obscured From View)
Supplied Tee Adapter
(P/N 333-0012-109)