Case WX210 - Safety Instructions, Maintenance;Servicing; Safety During Transport

0 - 22 SAFETY INSTRUCTIONS WX210 - WX240
Safety instructions, maintenance/servicing
40000024-en
Safety during transport
There is a risk of the machine over-
turning when it is being loaded onto
a truck or trailer and when it is be-
ing unloaded.
- Ensure that local regulations are
observed when the machine is be-
ing transported on the public
highway.
- An appropriate truck or trailer must
be provided for the transport of the
machine.
When loading/unloading the ma-
chine, the following precautions
must be taken:
- Find firm, horizontal ground.
- Always use a loading platform or
drive-on ramp.
- A marshaller must be enlisted to
help with loading/unloading the
machine.
- When loading or unloading the
machine, the automatic speed re-
set must always be switched off to
prevent an unexpected increase in
speed due to inadvertent activation
of an operating lever.
Always set the transmission stage
switch to "slow".
In the "fast" transmission stage, the
travelling speed may be automati-
cally increased.
- Avoid steering movements when
driving up or down the ramp, as
that is extremely dangerous. If
steering is absolutely essential,
first drive back onto the ground or
the loading area, correct the driv-
ing direction, and set off again.
- At the top end of the ramp, which
adjoins the loading area, there is a
joint. Drive over it with care.
- When slewing the superstructure,
avoid fast movements as they
might cause the machine to over-
turn, resulting in potential injury.
- Keep the stick retracted and turn
the superstructure slowly to en-
sure maximum stability.
- Secure the machine frame with
chains or cables.
Details are given in the appropriate
sections of the Owner’s Manual.
Fig. 23
Î
Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)