WX210 - WX240 SAFETY INSTRUCTIONS 0 - 31
Fire prevention
Removal of flammable substances:
- Spilt fuel or lubricant, waste, lubri-
cating grease, dirt, coal dust de-
posits and other flammable sub-
stances may cause fires.
- To prevent fires, the machine must
be checked and cleaned once a
day. Any spillages or deposits of
flammable substances must be
cleared away immediately.
Checking the ignition key function:
- If the engine is not shut off when
fire breaks out, the fire will spread,
impeding fire-fighting operations.
- Before starting daily machine op-
erations, the ignition key must be
checked for correct functioning.
Start up the engine and run it at a
low idling speed.
To confirm that the engine is shut
off, turn ignition key to OFF position.
- Any irregularities that are detected
must be rectified before the ma-
chine is put into operation.
Checking heat shields:
The absence of heat shields or any
damage to them may result in fire
breaking out.
Damaged or missing heat shields
must be repaired or replaced before
the machine is put into operation.
Checking for leakages:
- Leakages of fuel, hydraulic oil and
lubricants may cause fires.
- Check whether clips are missing or
loose, hoses are kinked, lines or
hoses rub against one another, the
oil cooler is damaged or oil cooler
flange screws are loose, allowing
oil to escape.
- Missing, loose or damaged clips,
lines, hoses, oil coolers or oil
cooler flange screws must be re-
placed, tightened or repaired.
- High-pressure lines must not be
bent or hammered.
- Never install bent or damaged
lines, tubes or hoses.
Checking for short-circuits:
- Short-circuits may cause fires.
- Ensure that all electrical connec-
tions are clean and have a firm fit.
Check before each shift or after ca.
ten operating hours whether electric
cables or lines are loose, kinked,
hardened or worn through.
- Check before each shift or after ca.
ten operating hours whether termi-
nal caps are missing or damaged.
- -Never start up the machine if ca-
bles or lines are loose, kinked, etc.
Î
Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)
To Next Page
Loading...
