WX210 - WX240 SAFETY INSTRUCTIONS 0 - 23
Safety during servicing operations
To prevent accidents:
- Before starting work, familiarize
yourself with the servicing proce-
dure.
- Keep the working area clean and
dry.
- Never perform any lubrication or
servicing work while the machine
is in motion.
Before carrying out servicing work
on the machine:
- Park the machine safely.
- Never leave the machine unsuper-
vised if servicing work has to be
carried out with the engine run-
ning.
- If the machine has to be raised, the
boom and stick must be positioned
at an angle of 90 - 110°. Secure the
machine components that have to
be raised for servicing or repair
work with appropriate supports.
- Work must never be done under a
raised machine that is supported
by the boom.
Certain components have to be
checked at regular intervals and
repaired or replaced if necessary.
Details are given in the correspond-
ing sections of the Owner’s Manual.
- Use original spares only.
- All components must be kept in a
good state and correctly installed.
Any defect must be repaired im-
mediately.
- Any damage must be rectified im-
mediately. Worn or non-
functioning components must be
replaced. Remove any lubricating
grease, oil and dirt deposits.
Disconnect the cable from the
negative pole of the battery before
doing any work on the electrical
system or arc welding on the ma-
chine.
Fig. 24
Fig. 25
Î
Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)
To Next Page
Loading...
