Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
●
To have an alarm or hourly time signal
sound again, turn it back on.
Note
●
Indicators are displayed while any of
the alarms or the hourly time signal is
turned on.
●
The applicable indicators are not
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Use (D) to scroll through the alarm ([1] to
[5]) and hourly time signal ([:00]) screens
until the one you want to turn off is
displayed.
3. Press (A) to turn off the displayed alarm or
the hourly time signal.
●
Each press of (A) cycles through the
alarm settings as shown below.
AA
A
Daily alarm on
One-time alarm on
Alarm off
●
Each press of (A) toggles the hourly
time signal between enabled and
disabled.
●
Turning off all alarms will cause [ALM]
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
Note
●
If [ALM] (alarm) is still displayed, it
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
Stopwatch
The stopwatch measures elapsed time in units
of 1/100 second up to 23 hours, 59 minutes,
59.99 seconds (24 hours).
When this maximum limit is exceeded,
elapsed time measurement returns to 0 and
timing continues from there.
Measuring Elapsed Time
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
1/100 seconds
Seconds
Hour, minute
2. Use the operations below to measure
elapsed time.
3. Press (B) to reset the stopwatch to all
zeros.
Watch Operation Guide 3569
12
To Next Page
Loading...
