Casio 3569 - Time Correction

Note
●
Auto Light is disabled when any one of
the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
●
Configuring the Auto Light Setting
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (L) for at least three seconds
to toggle Auto Light between enabled and
disabled.
●
[LT] is displayed while Auto Light is
enabled.
●
Specifying the Illumination Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least one second.
Release the button when the seconds
start to flash.
Seconds
3. Press (C) nine times.
[LT] appears on the display with [1] or [3]
flashing.
4. Press (D) to select an illumination
duration.
[LT1]: 1.5-second light
[LT3]: 3-second light
5. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Time Correction
Use the procedures in this section to adjust the
date and time settings.
Time Correction
Use the procedures in this section to adjust the
date and time settings.
●
Setting the Time/Date
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least one second.
Release the button when the seconds
start to flash.
Seconds
Watch Operation Guide 3569
7