Casio 3569 - Setting the Time; Using the Timer; Other Settings; Button Operation Tone Setting

Setting the Time
The countdown start time can be set in 1-
second units up to 24 hours.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (A) for at least one second.
This causes the hours digits to flash.
Hours
3. Use (B) and (D) to change the timer hours
setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
4. Press (C).
This causes the minutes digits to flash.
Minutes
5. Use (B) and (D) to change the timer
minutes setting.
6. Press (C).
This causes the seconds digits to flash.
7. Use (B) and (D) to change the seconds
setting.
8. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Setting a start time of [0:00 00]
performs a countdown of 24 hours.
Using the Timer
The timer counts down time in 1/10-second
units.
1. Enter the Timer Mode.
l
Navigating Between Modes
1/10 seconds
Seconds
Hour, minute
2. Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (B).
3. Press any button to stop the tone.
Other Settings
This section explains other watch settings you
can configure.
Button Operation Tone
Setting
Use the procedure below to enable or disable
the tone that sounds when you press a button.
●
If a setting screen (flashing setting) is
displayed or if an alarm or other beeper
operation is in progress, exit the setting
screen or wait until the beeper operation is
finished before trying to configure this
setting.
1. Hold down (C) for at least three seconds
to toggle the operation tone between
enabled and disabled.
●
[MUTE] is displayed while the button
operation tone is disabled.
●
Pressing (C) to perform this operation
also changes the watch mode.
Note
●
Note that alarm and timer tones will still
sound even while the operation tone is
muted.
Watch Operation Guide 3569
14