E-64
■ The hands of the watch suddenly start moving at high speed, even when I do
not perform any operation.
This could be due to any one of the following causes. In all cases, the hand movement
does not indicate malfunction, and should stop shortly.
The watch is recovering from a sleep state (page E-16).
•
The time setting is being adjusted following a successful auto time calibration •
signal receive operation (page E-18).
The watch is returning to the Timekeeping Mode automatically from the Alarm Mode
•
(page E-58).
■ Hands suddenly stop moving. Button operation also is disabled.
The watch may be in the power recovery mode (page E-14). Do not perform any
operation until the hands return to their normal positions (in about 15 minutes). The
hands should return to their correct positions when normal operation returns. To help
power recover, leave the watch in a location where it is exposed to light.
To Next Page
Loading...
