19990401
10-1-1
Connecting Two Units
10-1 Connecting Two Units
The following procedure describes how to connect two units with the connecting cable that
comes equipped as a standard accessory.
uu
uu
u To connect two units
1. Check to make sure that the power of both units is off.
2. Remove the covers from the connectors of the two units.
3. Connect the two units using the cable.
#Be sure you keep the connector covers in a
safe place so you can replace them after you
finish your data communications.
#Keep the connectors covered when you are not
using them.
Cable
To Next Page
Loading...
Need help?
General
