Casio DT-940 - Page 19

― 17 ―
3.3.7 LF-HOLDER AND LASER-FILTER DISASSEMBLY/ASSEMBLY (DT-940)
Procedures
(1) Remove two B screws (+, silver).
(2)
Remove LF-HOLDER-A.
(3) Remove LF-HOLDER-B and LASER-FILTER.
* LASER-FILTER is xed to CASE and LF-HOLDER-B with a W tape.
(1) B Screws
(2)
(3)
LF-HOLDER-B
(3)
LASER-FILTER
< Note >
Assemble LASER-FILTER as shown below.
Peel off paper from
the w tape.
* Wear globes and push 5 places evenly.
* Do not push with bear hand.
(3)
LASER-FILTER