162
Appendix
Other
The wrong date
and time are
displayed.
The date and time setting is off. Set the correct date and time
(page 132).
The messages on
the display are in
the wrong
language.
The wrong display language is selected. Change the display
language setting (page 133).
Images cannot be
transferred over a
USB connection.
1)The USB cable may not be connected securely. Check all
connections.
2)Your computer is running Windows 98SE or 98 and does not
have the USB driver installed. Install the USB driver (page
110). You can download the USB driver from the Official
CASIO Digital Camera Website at http://www.exilim.com/
3)Your computer is running Windows 98SE or 98 and does not
have the USB driver installed correctly. Reinstall the USB
driver correctly (page 110).
4)The wrong USB communication protocol is selected. Select
the correct USB communication protocol in accordance with
the type of device you are connecting (pages 110, 119).
5)If the camera is not turned on, turn it on.
Language selection
screen appears
when the camera is
turned on.
1)You did not configure initial settings after purchasing the
camera or the battery may have been left with a dead battery.
Check the camera setup (pages 13, 133).
2)There may be a problem with the camera’s memory data. If
this is the case, perform the reset operation to initialize the
camera’s setup (page 136). After that, configure each setting.
If the language selection screen does not re-appear when you
turn the camera on, it means that the camera’s memory
management data has been restored.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
Problem Possible Cause and Recommended Action
To Next Page
Loading...
Need help?
General
