124
Appendix
See page 23 for information about supported memory cards and how to load a
memory card.
Press the memory card and then release it. This will
cause it to pop out of the memory card slot slightly. Pull
the card out the rest of the way and then insert another
one.
• Never remove a card from the camera while the back
lamp is flashing green. Doing so can cause the image
save operation to fail and even damage the memory
card.
. Using a Memory Card
• SD memory cards, SDHC memory cards, and SDXC
memory cards have a write protect switch. Use the
switch when you need to guard against accidentally
deleting data. Note, however, if you write protect an SD
memory card you must then turn write protection off
whenever you want to record to it, format it, or delete
any of its images.
• If a memory card starts to behave abnormally during image playback, you can
restore normal operation by reformatting it (page 114). However, it is
recommended that you always take along multiple memory cards whenever using
the camera far away from the home or office.
• As you record data to and delete data from a memory card a number of times, it
loses its ability to retain data. Because of this, periodic re-formatting of a memory
card is recommended.
• Electrostatic charge, electrical noise, and other phenomena can cause data to
become corrupted or even lost. Make sure that you always back up important data
on other media (CD-R, CD-RW, hard disk, etc.).
Using a Memory Card
To replace the memory card
Write enabled
Write disabled
B
To Next Page
Loading...
Need help?
General
