34
Snapshot Tutorial
. To assign a priority level to pre-recorded face data
You can use the procedure below to assign names and priority levels to pre-recorded
faces.
1. In the REC mode, press [SET].
2. Use [8] and [2] to select the fifth Control Panel option from the top
(Face Recognition).
3. Use [4] and [6] to select “J Edit Family”
and then press [SET].
This will display the face data editing screen.
4. Use [8], [2], [4], and [6] to select the face
data you want to edit, and then press [SET].
5. Use [4] and [6] to select a name, and then
press [2].
6. Use [4] and [6] to select the priority level you want and then press
[SET].
• You can set the priority to one of four levels: q (Disabled: no detection),
and from s (Low) to v (High).
NOTE
• To delete pre-recorded face data, perform steps 1, 2, and 3 of the above procedure
and then press [MENU]. You can use the menu to select one face data record or all
face data records (page 34).
• Formatting the camera’s built-in memory (page 132) deletes all the recorded face
data.
Face data editing screen
To Next Page
Loading...
Need help?
General
Weight and Dimensions
