101
Dynamic Photo
Dynamic Photo
You can use the procedures in this section to crop either a
moving subject or a still subject out of a snapshot and then
insert it into another snapshot or movie.
1. In the REC mode, press [SET].
2. Use [8] and [2] to select the bottom Control Panel option (BS) and
then press [SET] (page 33).
3. Use [8], [2], [4], and [6] to select the “Dynamic Photo” scene and
then press [SET].
4. Press [SET], use [8] and [2] to select the third Control Panel option
from the bottom (Select Subject Type), and then press [SET].
5. Use [8] and [2] to select “Subject Type”, and then press [SET].
To create a subject image to be inserted (Dynamic Photo)
™
Moving Subject Another Image Dynamic Photo Image
To Next Page
Loading...
