19
Quick Start Basics
To replace the battery
1. Open the cover and remove the current
battery.
As shown in the illustration, pull up the edge of
the battery to remove it.
2. Load a new battery.
You can use either of the two following methods to charge the battery. Before
charging the battery, use the procedure under “Opening and Closing the Frame”
(page 13) to open the frame.
• USB-AC adaptor
• USB connection to a computer
. To charge with the USB-AC adaptor
The adaptor lets you charge the battery while it is loaded in the camera.
While the camera is turned off, connect in the sequence shown below.
Charging time: Approximately 140 minutes
• When disconnecting the USB-AC adaptor from the camera, be sure to disconnect
from the camera first.
Charge the Battery
3
2
1
USB-AC adaptor
u mark of the small (micro USB) connector
facing the side opposite that of the monitor screen.
[USB] port
Micro USB cable
(included with camera)
To Next Page
Loading...
General