29
Snapshot Tutorial
Snapshot Tutorial
The Control Panel can be used to configure camera settings.
1. In the REC mode, press [SET].
This will select one of the Control Panel icons and display its settings.
2. Use [8] and [2] to select the setting you want to change.
* Snapshot image quality cannot be changed using the Control Panel.
3. Use [4] and [6] to change the setting.
4. If you want to configure another setting, repeat steps 2 and 3.
5. After all of the settings are the way you want, press [SET].
This will apply the settings and return to the REC mode.
NOTE
• You can configure the camera to turn off display of the Control Panel when you
press [SET] (page 139).
• You also can configure settings other than those listed above (page 63).
• The Control Panel cannot be displayed while a Dynamic Photo, Prerecord Movie,
For YouTube, or Voice Recording Operation is in progress.
Using the Control Panel
[SET]
Control Panel
Available settings
[8] [2] [4] [6]
1
9
5
3
4
7
8
2
6
1
Image size/Quality* (pages 31, 80)
2
Flash (page 34)
3
AF Area (page 36)
4
Lighting (page 37)
5
ISO sensitivity (page 38)
6
Continuous shutter (page 39)
7
Face Detection/Make-up
(pages 42, 48)
8
EV shift (page 44)
9
Date/Time (page 45)
C
To Next Page
Loading...
