142
Other Settings (Set Up)
Procedure
[MENU] * Set Up Tab * Sounds
• Setting a volume level of 0 mutes output.
Procedure
[MENU] * Set Up Tab * Startup
Display the image you want to use as your startup image and then select “On”.
• The startup image does not appear when you turn on the camera by pressing [p]
(PLAY).
• You can specify a snapshot you recorded as the startup image, or you can use the
special startup image provided in the camera’s built-in memory.
• If you select an audio snapshot as the startup image, the audio will not play at
startup.
• Formatting built-in memory (page 149) will delete the current startup image setting.
Configuring Camera Sound Settings (Sounds)
Startup
Specifies the startup sound.
Sound 1 - 5: Built-in sounds (1 through 5)
Off: Sound off
Half Shutter
Shutter
Operation
Operation
Specifies the sound volume. This setting is also used as the
audio level during video output (page 90).
Play
Specifies the volume of movie and Audio Snapshot audio
output. This volume setting is not used during video output
(from the USB/AV port).
Configuring a Startup Image (Startup)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
