36
Snapshot Tutorial
1. In the REC mode, press [2] ( ) once.
2. Use [4] and [6] to select the flash
setting you want and then press [SET].
• You can select the flash mode by pressing
[2] ( ) in either of the following cases.
– When “Flash” is not shown on the control
panel (page 33)
– After [8] (DISP) is pressed to clear the information from the monitor screen
(page 150)
3. Press the shutter button to shoot.
• For information about Flash Range, see page 178.
Using Flash (Flash)
Auto Flash
Flash fires automatically in accordance with exposure
(amount of light and brightness) conditions.
Flash Off Flash does not fire.
Flash On
Flash always fires. This setting can be used to brighten a
subject that normally comes out dark due to daylight or
backlight (daylight synchro flash).
Soft Flash Soft flash always fires, regardless of exposure conditions
Red Eye
Reduction
Flash fires automatically. This type of flash can be used to
reduce the chance of redness in the subject’s eyes.
Back lamp
Flashes orange while the flash is charging to indicate that image
recording is disabled.
• You will not be able to take another flash snapshot until the lamp
stops flashing orange, which indicates that charging is complete.
< indicates the flash will fire.
Flash
[2] ( )
A
To Next Page
Loading...
Need help?
General
Weight and Dimensions
