53
Snapshot Tutorial
Due to the characteristics of the CMOS imaging element, shooting fast-moving
subjects with High Speed CS may cause the subject to become distorted. If this
happens, try shooting with F CS (Full pixels Continuous Shutter), which uses the
mechanical shutter only and eliminates the problems caused by the CMOS imaging
element characteristics. Note that the following settings are available when shooting
with F CS.
CS Speed (frames per second): 3 fps, 5 fps, 10 fps
Maximum Number of Shots: 5, 10, 20, 30
Also, note that F CS does not support Prerecord CS.
. Getting Ready
1. Set the mode dial to t (Auto).
2. In the REC mode, press [MENU].
3. Use [4] and [6] to select the “REC” tab.
4. Use [8] and [2] to select “CS” and then press [6].
5. Use [8] and [2] to select “F CS”, and then press [SET].
6. Press Õ (Continuous Shutter).
• This will display á (F CS). If this does not happen, press Õ again.
7. Press [SET].
8. Use [8] and [2] to select the fourth control panel option from the
bottom (F CS fps).
9. Use [4] and [6] to select the continuous shutter (CS) speed you want.
Enables specification of the number of CS images recorded per second.
10.
Use [8] and [2] to select the third control panel option from the
bottom (Max CS shots).
11.
Use [4] and [6] to select the maximum number of shots for each
continuous shutter operation.
12.
Press [SET].
High Speed CS Shooting Using the Mechanical Shutter Only
(F CS)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
