121
Viewing Snapshots and Movies
. Selecting the HDMI Terminal Output Method (HDMI Output)
Procedure
[MENU] * “¥ SETTING” Tab * HDMI Output
Use this setting to select the digital signal format when connecting to a TV with an
HDMI cable.
* 1080i corresponds to 1080 60i, but not 1080 50i. Because of this, the required
output method may be 576p when outputting to a digital TV in a PAL reception area
that does not support 1080i 60i. If you are in a PAL reception area and nothing is
displayed automatically, change the setting to 576p.
• If an image does not appear when “Auto” is selected as the output method, try
changing this setting to something else.
IMPORTANT!
• The “HDMI Output” setting cannot be changed as long as there is an HDMI cable
connection between the camera and a TV. Disconnect the HDMI cable from the
camera to change the “HDMI Output” setting.
Recording Camera Images to a DVD Recorder or Video Deck
Use the following method to connect the camera to the recording device using the AV
cable (option).
– DVD recorder or video deck: Connect the AV cable to the VIDEO IN and AUDIO IN
terminals.
– Camera: Connect the AV cable to the USB/AV port.
You can play a slideshow of snapshots and movies on the camera and record it on a
DVD or video tape. You can record movies by selecting “» Only” for the slideshow
“Images” setting (page 122).
For information about connecting a monitor to the recording device and about how to
record, see the user documentation that comes with the recording device you are
using.
Auto
This setting will cause the format to change automatically in accordance
with the connected TV. Normally, you should use this mode.
1080i 1080i format output*
480p 480p format output
576p 576p format output
To Next Page
Loading...
Need help?
General
