16
Quick Start Basics
To replace the battery
1. Open the battery cover and
remove the current battery.
2. Load a new battery.
You can use either of the two following methods to charge the camera’s battery.
• USB-AC adaptor
• USB connection to a computer (Using the included USB cable.)
. To charge with the USB-AC adaptor
The adaptor lets you charge the battery while it is loaded in the camera.
While the camera is turned off, connect in the sequence shown below.
The back lamp should light red, indicating that charging has started.
The back lamp will go out when charging is complete.
Charging time: Approximately 240 minutes
• When disconnecting the USB-AC adaptor from the camera, be sure to disconnect
from the camera first.
Charge the Battery
Stopper
3
4
2
1
3
2
1
USB-AC adaptor (AD-C53U)
Making sure that the 6 mark on the camera is aligned with the 4 mark of
the USB cable connector, connect the cable to the camera.
[USB/AV] port
USB-AC adaptor
(AD-C54UG)
USB cable
(included with camera)
Power cord
B
To Next Page
Loading...
