37
Snapshot Tutorial
IMPORTANT!
• In the S mode, ISO sensitivity (page 44) always operates according to its “Auto”
setting. The ISO sensitivity setting cannot be changed while in the S mode.
• The flash > (Auto Flash) and ¥ (Red Eye Reduction) flash modes are not
supported while A, S, or M is selected for the recording mode. If you want the flash
to fire, select < (Flash On) as the flash mode.
• The displayed ISO sensitivity, shutter speed or aperture value will turn red when
you half-press the shutter button if the image is overexposed or underexposed.
M M (Manual Exposure) mode
This mode gives you total control over aperture and shutter speed settings.
1
Press [SET] to open the Control Panel.
2
Use [8] and [2] to select
A
(Aperture), and then press [SET].
3
Use [8] and [2] to change the aperture setting, and then press [SET].
4
Use [8] and [2] to select
S
(Shutter Speed), and then press [SET].
5
Use [8] and [2] to change the shutter speed setting, and then press [SET].
S S (Shutter Speed Priority) mode
In this mode, you select the shutter speed and other settings are adjusted
accordingly.
1
Press [SET] to open the Control Panel.
2
Use [8] and [2] to select
S
(Shutter Speed), and then press [SET].
3
Use [8] and [2] to change the shutter speed setting, and then press [SET].
• You also can select the EV shift setting located under the shutter speed
setting and then specify an exposure value (EV shift), if you want.
A A (Aperture Priority) mode
In this mode, you select the aperture and other settings are adjusted
accordingly.
1
Press [SET] to open the Control Panel.
2
Use [8] and [2] to select
A
(Aperture), and then press [SET].
3
Use [8] and [2] to change the aperture setting, and then press [SET].
• You also can select the EV shift setting located under the aperture setting
and then specify an exposure value (EV shift), if you want.
To Next Page
Loading...
Need help?
General
