47
Snapshot Tutorial
If you plan to use flash, you need to slide the flash switch
to open the flash unit.
1. In the REC mode, press [2] ( ) once.
2. Use [8] and [2] to select the flash setting
you want and then press [SET].
3. Slide the flash switch to open the flash unit.
• If you half-press the shutter button while the flash unit is not open when
surrounding light requires flash, the message “Open the flash unit.” will appear
on the monitor screen. The flash will not fire if you go on and fully press the
shutter button. Slide the flash switch to open the flash unit before shooting.
Using Flash (Flash)
Setting
REC Screen
Icon Display
Description
Auto Flash None
Flash fires automatically in accordance with
exposure (amount of light and brightness)
conditions.
Flash Off Flash does not fire.
Flash On
Flash always fires. This setting can be used to
brighten a subject that normally comes out dark
due to daylight or backlight (daylight synchro
flash).
Red Eye
Reduction
Flash fires automatically. This type of flash can
be used to reduce the chance of redness in the
subject’s eyes.
Flash
Flash switch
[2] ( )
To Next Page
Loading...
