E-67
3. After inputting everything you want, press
E
.
• This registers your input. If you input expressions, the calculation result of the
expression is registered.
• While any setting is highlighted, press
E
to display the sequence table screen (page
67).
Returning to the Sequence Editor Screen from the Table Range
Screen
Press
J
.
A
Sequence Table Screen
When you press
E
in step 3 under “Specifying the Initial Term, Start Value, and End
Value”, the calculator will perform the sequence calculation in accordance with the formula
(general term or recursion formula), initial term, start value, and end value that you have
input, and display the result on the sequence table screen.
a
n
Type Sequence
a
n
+1
Type Sequence
• Each of cells on the sequence table screen shows up to six digits of the value currently
stored in the cell.
• To see the full value in a cell, move the highlighting to it. The full value contained in the
cell will appear in the value display area at the bottom of the screen.
• While a value is in the value display area, you can convert it using ENG conversion (page
53), sexagesimal-decimal conversion (page 27), or decimal-fraction format conversion
(page 22).
• Note, however, that you cannot input into the value display area or edit the values
displayed there.
Sequence Table Columns
This column: Contains this data:
n
Value from the start value to the end value specifi ed for
n
on the
table range screen.
a
n
Value of
a
n
for the
n
-value in the same line.
Σ
a
n
Sum of
a
n
from start value of
n
up to the
n
-value in the same line
n
+1
Value from the start value to the end value specifi ed for
n
+1 on the
table range screen.
a
n
+1
Value of
a
n
+1
for the
n
+1 value in the same line.
Σ
a
n
+1
Sum of
a
n
+1
from
a
1
to
n
+1 in the same line.
Returning to the Table Range Screen from the Sequence Table Screen
Press
J
.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
