9. Use (C) to move the pointer to [YES]
.
●
To stop the reset operation, move the
pointer to [NO].
10. Press (A).
After the reset operation is complete, the
watch will return to the current time
screen. The reset operation is complete
when [AC] appears in the lower right
corner of the display.
11. Press (A) to clear
[AC] from the display.
Note
●
Resetting the watch will also delete
information for
pairing the watch with a
phone, and unpair them.
Phone Finder
You can use phone finder to trigger a sound
on the paired phone to help you find it. The
sound operation is performed even if your
phone is in vibrate mode.
Important!
●
Phone finder will not sound the tone
unless the CASIO WATCHES phone
app is running on the phone.
●
Do not
use this function in areas where
phone call tones are restricted.
●
The tone sounds at a high volume. Do
not use this function when listening to
phone output over earphones.
1. Display the current time screen.
l
Watch Mode
2. Hold down (C) for at least two seconds.
This enters the Control Mode.
3. Use (C) to select
[PHONE FINDER]
.
4. Press (A).
This will establish a connection between
the watch and phone, and sound the
phone’s ringtone.
●
It will take a few seconds before the
phone tone sounds.
●
[FAILED]
appears when a phone finder
operation is unsuccessful.
5. Press any button to stop the sound.
●
You can
press any watch button to stop
the phone tone only during the first 30
seconds after it starts to sound.
Note
●
Connection with your phone is not
possible while the watch’s Airplane
Mode is
enabled. To connect with your
phone, disable the Airplane Mode.
l
Entering the
Watch Airplane Mode
Entering the Watch Airplane
Mode
When you are in a hospital, on an aircraft, or
in any other location where connection with a
phone may cause problems, turn on the
watch’s Airplane Mode. To turn off the
Airplane Mode, perform the same operation
again.
1. Display the current time screen.
l
Watch Mode
2. Hold down (C) for at least two seconds.
This enters the Control Mode.
3. Use (C) to select [AIRPLANE MODE].
4. Press (A).
5. Use (C) to select an Airplane Mode
setting.
[OFF] Exits Airplane Mode.
[ON] Enables Airplane Mode.
6. Press (A) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the Airplane Mode screen re-
appears.
7. Press (D) to exit the setting screen.
●
is displayed while the watch is in the
Airplane Mode.
Watch Operation Guide 3516
67