Casio KL-HD1 - Page 22

20
EN
Error Messages/Display Messages
Message Possible Causes Action
LABEL LONGER
THAN SETTING!
OK/CANCEL
•
This message appears
when the length of the
tape that will actually
be printed is longer
than the specifi ed
tape length.
• To print, press OK.
• To cancel printing, press
.
You can then decrease the
number of characters, change
to a longer tape setting, or
select auto tape length.
LOAD A TAPE
CARTRIDGE
12mm OR 18mm
• You are trying to use
the Logo function
while a 6mm (
1
/
4
")
or 9mm (
3
/
8
") tape
cartridge is loaded in
the printer.
•
Turn off the printer and replace
the tape cartridge with a
12mm (
1
/
2
") or 18mm (
3
/
4
")
cartridge, and specify the tape
width setting on the printer.
LOW BATTERY!
• Battery power is low. • Replace the batteries.
NO DATA!
• You are attempting
to recall text from
memory when there
is none stored.
• Store the text in memory and
then try again.
NO INPUT
TEXT!
• You are attempting
a print or preview
operation when no
text is input.
• Input the text and then try
again.
PRINT ERROR!
• The tape became
jammed during
printing.
• Turn off the printer and
remove the tape cartridge.
Next, remove the jammed
tape.
• If the steps described above
do not clear the error message,
contact your retailer or your
nearest CASIO service center.
Message Possible Causes Action
PRINTER NOT
SHUT DOWN
PROPERLY
LAST TIME
• You removed the
batteries the last time
power was turned on
or while the message
“PLEASE WAIT”
was displayed, so the
printer did not power
down normally.
• Press any key to initialize the
data that was partially deleted
the last time the printer
powered down.
TOO MANY
CHARACTERS!
• You are attempting
to input more than
80 characters of
text.
• Reduce the number of input
characters.
TOO MANY
LINES!
• The number of line
breaks you input
caused the label to
exceed the maximum
number of lines for
the tape you are
using.
• You are attempting
to print more than
three lines while an
18mm (
3
/
4
") tape
cartridge is loaded.
•
You are attempting to
print more than two
lines while a 12mm
(
1
/
2
") tape cartridge is
loaded.
• You are attempting
to print more than
one line while a 6mm
(
1
/
4
") or 9mm (
3
/
8
")
tape cartridge is
loaded.
• Use wider tape or reduce
the number of lines. The
maximum number of lines
for each tape width is shown
below.
6mm (
1
/
4
") tape...1 line
9mm (
3
/
8
") tape...1 line
12mm (
1
/
2
") tape...Up to 2
lines
18mm (
3
/
4
") tape...Up to 3
lines
• Use wider tape or reduce the
number of lines with frame.
The maximum number of lines
for each tape width when
printing with a frame is shown
below.
6mm (
1
/
4
") tape...1 line
9mm (
3
/
8
") tape...1 line
12mm (
1
/
2
") tape...1 line
18mm (
3
/
4
") tape...Up to 2
lines