Casio MZ-X300

Receive Receipt changes the mixer part volume.
7.6 Pan (0AH)
Message Format: BnH 0AH vvH
n: MIDI Channel Number
vv: Value(Note1)
Note1: For information about the relationship between setting values and send/receive values, see “26.5 Pan Setting Value
Table” in “VII Setting Values and Send/Receive Values”.
Transmit Sent when the pan of any part is changed.
Receive Receipt changes the pan of the corresponding part.
7.7 Expression (0BH)
Message Format: BnH 0BH vvH
n: MIDI Channel Number
vv: Value
Transmit Sent when Auto Acompanishment is used and during recorded song playback.
Receive Receipt changes the Expression value.
7.8 General Use Controllers 1 through 8 (10H through 13H, 50H through
53H)
On this Instrument, these messages are used to control DSP operation.
Message Format: BnH 10H vvH DSP Parameter[1]
BnH 11H vvH DSP Parameter[2]
BnH 12H vvH DSP Parameter[3]
BnH 13H vvH DSP Parameter[4]
BnH 50H vvH DSP Parameter[5]
BnH 51H vvH DSP Parameter[6]
BnH 52H vvH DSP Parameter[7]
BnH 53H vvH DSP Parameter[8]
n: MIDI Channel Number
vv: Value
Receive Receipt changes the value of DSP Parameter [1 to 8] (7-bit parameter) assigned to the part
specified by the MIDI Channel Number. Any message received that corresponds to the parameter of a
numb er not being used by the currently selected DSP is ignored. Use NRPN to change DSP parameters
from DSP Parameter [9] with a MIDI message. For details,see ”7.25 NRPN”. For details about each
DSP parameter, see ”VI DSP Parameter List”.
10