Note1: For information about the relationship between setting values and send/receive values, see “26.4 –64 - 0 - +63 Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
Note2: For information about the relationship between setting values and send/receive values, see “26.12 LFO Wave Form1
Setting Value Table” in “VII Setting Values and Send/Receive Values” of this document.
25.7 Chorus
Parameter Number Parameter Name Notes
Parameter[1] LFO Rate
Parameter[2] LFO Depth
Parameter[3] LFO Waveform Note1
Parameter[4] Feedback Note2
Parameter[5] Wet Level
Parameter[6] Polarity Note3
Parameter[7] Input Level
Parameter[8] Dry Level
Note1: For information about the relationship between setting values and send/receive values, see “26.13 LFO Wave Form2
Setting Value Table” in “VII Setting Values and Send/Receive Values” of this document.
Note2: For information about the relationship between setting values and send/receive values, see “26.4 –64 - 0 - +63 Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
Note3: For information about the relationship between setting values and send/receive values, see “26.15 Polarity Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
25.8 Flanger
Parameter Number Parameter Name Notes
Parameter[1] LFO Rate
Parameter[2] LFO Depth
Parameter[3] LFO Waveform Note1
Parameter[4] Feedback Note2
Parameter[5] Wet Level
Parameter[6] Input Level
Parameter[7] Dry Level
Note1: For information about the relationship between setting values and send/receive values, see “26.12 LFO Wave Form1
Setting Value Table” in “VII Setting Values and Send/Receive Values” of this document.
Note2: For information about the relationship between setting values and send/receive values, see “26.4 –64 - 0 - +63 Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
25.9 Tremolo
Parameter Number Parameter Name Notes
Parameter[1] LFO Rate
Parameter[2] LFO Depth
Parameter[3] LFO Waveform Note1
Parameter[4] Wet Level
Parameter[5] Dry Level
Note1: For information about the relationship between setting values and send/receive values, see “26.14 LFO Wave Form3
Setting Value Table” in “VII Setting Values and Send/Receive Values” of this document.
41
To Next Page
Loading...
