25.10 Auto Pan
Parameter Number Parameter Name Notes
Parameter[1] LFO Rate
Parameter[2] LFO Depth
Parameter[3] LFO Waveform Note1
Parameter[4] Manual Note2
Parameter[5] Wet Level
Parameter[6] Dry Level
Note1: For information about the relationship between setting values and send/receive values, see “26.14 LFO Wave Form3
Setting Value Table” in “VII Setting Values and Send/Receive Values” of this document.
Note2: For information about the relationship between setting values and send/receive values, see “26.4 –64 - 0 - +63 Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
25.11 Rotary
Parameter Number Parameter Name Notes
Parameter[1] Speed Note1
Parameter[2] Brake Note2
Parameter[3] Fall Accel
Parameter[4] Rise Accel
Parameter[5] Slow Rate
Parameter[6] Fast Rate
Parameter[7] Vibrato/Chorus Note3
Parameter[8] Wet Level
Parameter[9] Dry Level
Note1: For information about the relationship between setting values and send/receive values, see “26.16 Slow/Fast Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
Note2: For information about the relationship between setting values and send/receive values, see “26.17 Rotate/Stop Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
Note3: For information about the relationship between setting values and send/receive values, see “26.18 Vibrato/Chorus
Setting Value Table” in “VII Setting Values and Send/Receive Values” of this document.
25.12 Drive Rotary
Parameter Number Parameter Name Notes
Parameter[1] Overdrive Gain
Parameter[2] Overdrive Level
Parameter[3] Speed Note1
Parameter[4] Brake Note2
Parameter[5] Fall Accel
Parameter[6] Rise Accel
Parameter[7] Slow Rate
Parameter[8] Fast Rate
Parameter[9] Vibrato/Chorus Note3
Parameter[10] Wet Level
Parameter[11] Dry Level
Note1: For information about the relationship between setting values and send/receive values, see “26.16 Slow/Fast Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
Note2: For information about the relationship between setting values and send/receive values, see “26.17 Rotate/Stop Setting
Value Table” in “VII Setting Values and Send/Receive Values” of this document.
42
To Next Page
Loading...
