Casio MZ-X500 - Page 22

Editing a Tone (User Tones)
EN-21
Chorus Gives notes depth and breadth.
LFO Rate (X) Adjusts the LFO rate. 0 to 127
LFO Depth (Y) Adjusts the LFO depth. 0 to 127
LFO Waveform Selects the LFO waveform. Sin, Tri
Feedback Adjusts the strength of feedback. –64 to 0 to +63
Wet Level Adjusts the level of the effect sound. 0 to 127
Polarity Inverts the LFO of one channel. –, +
Input Level Adjusts the input level. 0 to 127
Dry Level Adjusts the level of the direct sound. 0 to 127
Flanger Applies wildly pulsating and metallic reverberation to notes.
Selects the LFO waveform.
LFO Rate (X) Adjusts the LFO rate. 0 to 127
LFO Depth (Y) Adjusts the LFO depth. 0 to 127
LFO Waveform Selects the LFO waveform. Sin, Tri, Random
Feedback Adjusts the strength of feedback –64 to 0 to +63
Wet Level Adjusts the level of the effect sound. 0 to 127
Input Level Adjusts the input level. 0 to 127
Dry Level Adjusts the level of the direct sound. 0 to 127
Tremolo Shifts the volume of the input signal using an LFO.
LFO Rate (X) Adjusts the LFO rate. 0 to 127
LFO Depth (Y) Adjusts the LFO depth. 0 to 127
LFO Waveform Selects the LFO waveform. Sin, Tri, Tra
Wet Level Adjusts the level of the effect sound. 0 to 127
Dry Level Adjusts the level of the direct sound. 0 to 127
Auto Pan Shifts the continual left-right panning of the input signal using an
LFO.
LFO Rate (X) Adjusts the LFO rate. 0 to 127
LFO Depth (Y) Adjusts the LFO depth. 0 to 127
LFO Waveform Selects the LFO waveform. Sin, Tri, Tra
Manual Adjusts the pan (stereo position). –64 is full left, 0 is center, and
+63 is full right.
–64 to 0 to +63
Wet Level Adjusts the level of the effect sound. 0 to 127
Dry Level Adjusts the level of the direct sound. 0 to 127
DSP type/Parameter Description Settings