Using the Pattern Sequencer
EN-33
1.
On the PATTERN SEQUENCER screen,
touch “Mixer Edit”.
This displays the MIXER EDIT screen.
2.
Configure parameter settings as required.
• Touch a display item and then select from the list that
appears. Use the 9 w /NO, q/YES buttons to
change setting values.
3.
Touch bo EXIT to return to the RHYTHM
EDIT MENU screen.
4.
Save the edited rhythm using the procedure
under “Saving a User Rhythm” (page EN-34).
• The following procedure imports SMF format MIDI
data stored on a USB flash drive into Digital
Keyboard memory as a User Rhythm.
1.
On the PATTERN SEQUENCER screen,
touch “SMF Import”.
This displays the SMF IMPORT screen.
• If there is no file that contains MIDI data, the message
“No File!” will appear on the display.
2.
Select the data you want to import and then
touch “Select”.
This displays the SMF IMPORT SETTING screen.
To adjust the balance between parts
Item Description
Part Switches a part on or off.
Tone Specifies the tone of each part. Tones that
can be selected depend on the part type.
Volume Adjusts the volume level of each part.
Pan Adjusts the pan position of each part.
Reverb Send Specifies how much reverb is applied to
each part.
Chorus Send Specifies how much chorus is applied to
each part.
Delay Send Specifies how much delay is applied to
each part.
Solo Sounds the currently selected parts only.
The currently selected parts are indicated
in the level meter in the lower right
corner of the display.
To select a different part, touch the
“Volume” or other editable parameter of
the desired part.
Level/Param
switch
Toggles the level meter display between
volume levels and parameter settings.
To import MIDI data into Digital Keyboard
memory from a USB flash drive
To Next Page
Loading...
Need help?
General
Weight and Dimensions
