EN-31
Getting Ready
• Before starting assembly, check to make sure that
you have all the parts shown below.
• This stand does not include any of the tools required
for assembly. It is up to you to prepare a large
Philips head (+) screwdriver for assembly.
• Do not remove the tape securing the keyboard cover
in place until assembly is complete. Removing the
tape can cause the keyboard cover to open and
close during assembly, creating the risk of personal
injury to your hands and fingers.
• Do not use any screws other than those that come
with the stand. Doing so risks damage to the stand
and/or Digital Piano.
•You can find the screws in a plastic bag inside of the
packing material.
• If anything is missing or damaged, contact your local
CASIO service provider.
*CAUTION
• To assemble the stand, at least two persons should
work together on a flat surface.
• Take care that you do not pinch your fingers
between parts when assembling them.
• Spread felt or some other type of cloth under the
bench to avoid direct contact between the rubber at
the tips of the legs and the floor surface. Direct
contact between the rubber and flooring can cause
discoloration, marring, or other damage to the
flooring.
• When placing the Digital Piano on the floor, be sure
to place it on something soft (a blanket, cushion, etc.)
Do not place the Digital Piano directly onto the floor.
NOTE
• Be sure to follow the proper procedure when
assembling the stand.
• Pull the pedal unit cable out from the pedal unit
.
Assembling the Stand
Side panel ........................... ×1
Side panel ........................... ×1
Back board .......................... ×1
Pedal unit ............................ ×1
Screws ................................ ×2
Screws ................................ ×4
Brackets .............................. ×2
Screw caps ......................... ×2
Screw caps ......................... ×6
Clips .................................... ×2
To Next Page
Loading...
Need help?
General
