Getting Ready
EN-33
4.
Insert angle brackets into the gap between
the anti-tipping bracket and the side panel.
5.
From the outside of side panels
and
,
temporarily tighten the screws you loosened
in step 3, above.
6.
Place the two ends of the pedal unit onto
the
brackets and secure them with
screws. Finish with
screw caps.
7.
While pressing the pedal unit down towards
the floor, securely tighten the screws you
partially tightened in step 5.
8.
From the back of the assembled stand, slide
the piano into the grooves of side panel
and side panel
.
• Note that there is nothing anchoring the piano to the
stand at this time. Take care to ensure that the piano
does not fall off the stand.
9.
Use
screws to secure the piano to the
stand from both the front and the back.
To Next Page
Loading...
Need help?
General
