EN-52
Getting Ready
(PX-870 only)
8.
Secure the back panel
to the back board
.
• Place the back panel
onto pedal unit
so it is in
front of the three screw lugs of the pedal unit.
• Screw the screws
into the five holes in the back
panel
.
• Go around to the front of the Digital Piano and
securely tighten the three screws
shown in the
illustration below.
9.
From the back of the assembled stand, slide
the piano into the grooves of side panel
and side panel
.
• Note that there is nothing anchoring the piano to the
stand at this time. Take care to ensure that the piano
does not fall off the stand.
10.
Use
screws to secure the piano to the
stand from both the front and the back.
To Next Page
Loading...
