PX-150
– 37 –
Preparation
(1) Connect the AC adaptor.
(2) Connect the pedal (SP-3, SP-20, or SP-33).
NOTE: SP-3 is the pedal that comes with this digital piano. Connect it to the DAMPER PEDAL jack
on the back of the digital piano.
NOTE: SP-20 is a pedal sold separately. Connect it to the DAMPER PEDAL jack on the back of
the digital piano.
NOTE: SP-33 is a pedal unit sold separately. Connect it to the pedal connector on the bottom of
the digital piano. The stand CS-67P (sold separately) is required to use the pedal unit SP-
33.
NOTE: The “Pedal Check” cannot be performed without a pedal.
(3) Adjust the main volume so that it is at about 1/3 of the full volume.
(4) Have a PC and USB cable ready.
NOTE: Please refer to the user’s guide for PC system requirements.
NOTE: The “USB Check” cannot be performed without a PC and a USB cable.
To Next Page
Loading...
