Note: X 0 through 5 correspond respectively to Layers 1 through 6.
Note1: For information about the relationship between setting values and send/receive values, see “33.1 Off/On Setting Value
Table” in “VIII Setting Values and Send/Receive Values” of this document.
Note2: For information about the relationship between setting values and send/receive values, see “33.28 Octave Shift Setting
Value Table” in “VIII Setting Values and Send/Receive Values” of this document.
Note3: For information about the relationship between setting values and send/receive values, see “33.5 Pan Setting Value
Table” in “VIII Setting Values and Send/Receive Values” of this document.
Hex Layer Detune
Parameter MSB LSB Notes
Detune 56H 00H Note1
Note1: For information about the relationship between setting values and send/receive values, see “33.27 Hex Layer Detune
Setting Value Table” in “VIII Setting Values and Send/Receive Values” of this document.
Drum Inst Edit Setting values are applied in relation to reference values possessed by tones.
Parameter MSB LSB Notes
Filter Cutoff 14H XXH
Filter Resonance 15H XXH
Amp&Filter Attack Time 16H XXH
Amp&Filter Decay Time 17H XXH
Coarse Tune 18H XXH
Fine Tune 19H XXH Note1
Volume 1AH XXH
Pan 1CH XXH
Reverb Send 1DH XXH
Chorus Send 1EH XXH
Delay Send 1FH XXH
Note: XX 00 through 7F correspond respectively to Inst C- through G9.
Note1: For information about the relationship between setting values and send/receive values, see “33.26 –256 - 0 - +255
Setting Value Table” in “VIII Setting Values and Send/Receive Values” of this document.
7.26 RPN (64H,65H)
Message Format: BnH 64H llH (LSB)
BnH 65H mmH (MSB)
n: MIDI Channel Number
ll: LSB Value
mm: MSB Value
19
To Next Page
Loading...
